User Manual

Basic Operation

■

Program Scan

This function scans a specified range of frequencies. Before operating this

function, you need to specify the upper and lower frequency limits. These

frequencies are called a "Program channel", and the DJ-X3 has 20 pairs of

program channels. Set the combination of upper and lower limits. (i.e. A00 and

B00, or A01 and B01) For more information, see "Programming a Channel."

(P.24)

1 Switch to the VFO mode by pressing the [V/P/M (MW)] key.

2 Press the [SCAN(SCRT)] key.

3 Rotate the dial as holding the [SCAN(SCRT)] key, and select a set of

program channel which is to be scanned.

Frequencies between A and B of the same No. will be scanned.

4 Release the [SCAN(SCRT)] key.

Program scan starts. ". (decimal point)" flashes, and "PS" appears on the

display. Scanning pauses when receiving a signal.

Tip

The tuning step and modulation mode of Program scan depends on not the

settings in the Memory mode, but the settings in the VFO mode.

ProgramchannelNo.

Flashes

POWER

SCAN

SCRT

V/P/M

BANK

WIDE BAND

COMMUNICATION RECEIVER

DJ-X3

1M/10M

2.3.4