User Manual

Basic Operation

■

Programming a Channel

1 In VFO mode, select the frequency which you want to program.

2 Press the [FUNC/ENTER] key.

"F", bank No., and channel No. will appear on the display.

3 Select a bank by pressing the [BANK(1M/10M)] key.

Each bank No. corresponds to the following bank.

0 - 9 ·········································· For Memory channel

A, B ·········································· For Program scan channel

P ··············································· For Priority channel

J ··············································· For Search-pass memory channel

Select a bank according to the use.

4 Select a channel by rotating the dial.

According to the type of bank, available channels are different as shown

below.

Bank 0 - 9 ································· 00 - 69

Bank A, B ································· A00 - B19

Bank P ······································ 00 - 07

Bank J ······································ 00 - 99

If bank No. flashes, the channel is available and if it appears on the display,

a channel

(S) is already programmed.

5 Press the [V/P/M (MW)] key.

The setting will be completed.

Tip

· It is not possible to increase the number of memory channels.

· It is not possible to overwrite the memory in the default setting. For more

information, see "Overwrite Memory Setting." (P.44)

BankNo. ChannelNo.

POWER

SCAN

SCRT

V/P/M

BANK

1M/10M

1.5