User Manual

6. Useful Functions
41
6
6-1-4 Programmed scan
The Programmed scan searches a range of frequencies specied by
upper and lower limits. The specied upper and lower frequencies are
collectively reffered to as a "programmed scan channel". The DJ-X30 can
store up to 50 pairs of programmed scan channels. For more information,
refer to "Programming a memory channel" (
+
P. ••). Note that you need to
program data in the bank for programmed scan channels in advance. If
you do not do this, the following operation cannot be performed.
1
Press the key to switch to VFO mode, if necessary.
2
While holding down the
key,
rotate the dial until "PRGRM"
appears on the LCD. Select
a pair of programmed scan
channels to use for the scan.
3
Release the key to start scanning.
During scanning, the decimal point of the displayed frequency blinks.
6-2 Memory Skip Function
The Memory Skip function enables you to skip a specied memory channel
during the Memory scan operation. Since scanning always stops at active
channels, skipping such channels ensures efcient scanning.
1
Press the key to switch to Memory mode.
2
Select the memory channel you want to skip.
3
Press the [FUNC] key to display the icon on the LCD.
4
Press the [MONI] key.
"SKIP" appears on the left of the LCD,
indicating that the Memory Skip function
is set to the channel.
To deactivate the Memory Skip function,
select the memory channel and follow
steps
3
and
4
above.
The "SKIP" icon on the LCD disappears and the function is deactivated.