User Manual

5. Basic Operation
35
5
CAUTION
• You cannot program duplicated frequencies to the bank for skip-search
channels. If you try to do so, an error beep will sound.
•
The data factory-written to the memory has been edited by Alinco. Note
that the assigned frequencies and modulation types may change at a
later time. Although Alinco reviews the data from time to time, we do not
guarantee the reliability of the data. It is the responsibility of the user
to maintain this memory data by referring to commercially-available
frequency lists or other references as necessary.
5-6-2 Programming a memory channel
1
In VFO mode, tune to the frequency you want to
program by rotating the dial.
2
Press the [FUNC] key to display the icon on the upper
left of the LCD.
3
Press the key to select a bank.
Each bank corresponds to the following memory channels.
0 to 9 Banks for normal memory channels
(Note that the default settings of 0 to 9 may change due to
reasons such as changes in memory data.)
PS Bank for programmed scan channels
PA Bank for skip-search channels
Pr Bank for priority channels
Select an appropriate bank according to the usage.
4
Rotate the dial to select a channel.
The number of programmable channels differs depending on the bank
type as follows:
0 to 9 000 to 099
(The number of programmable channels varies depending on
how you separate each bank.)
PS 0A to 49b
PA 000 to 099
Pr 000 to 099
A blinking channel number indicates that no data is programmed to the
channel.
A channel number which does not blink and is displayed constantly
indicates that data has been programmed to the channel.