User Manual

32
5. Basic Operation
5
●
Selectable tuning steps
Auto, 5 kHz, 6.25 kHz, 8.33 kHz, 10 kHz, 12.5 kHz, 15 kHz, 20 kHz, 25 kHz,
30 kHz, 50 kHz, 100 kHz, 125 kHz, 150 kHz, 200 kHz, 500 kHz, 1 MHz
*1 : Only 1 kHz tuning step is available. This cannot be changed.
*2 : Only 9 kHz tuning step is available. This cannot be changed.
1
Press the key to select a band to change its tuning
step.
2
Press the [FUNC] key to display the icon on the LCD.
3
Press the [MONI] key. "AUTO" appears on the LCD.
4
Press the [MONI] key again. The selection changes from
"AUTO" to other tuning steps.
5
Rotate the dial to select a tuning step. The selection
returns to "AUTO" when the [MONI] key is pressed
again.
6
Press the [FUNC] key to nish the setting. The LCD
returns to the frequency display.
When a tuning step other than "AUTO" is selected for any one band,
"AUTO" is cancelled for all bands. The last selected tuning step is stored
for each band.
When "AUTO" is selected again for any one band, "AUTO" is selected for
all bands. Then, the tuning step specied for the DJ-X30 is automatically
selected.
5-5-3 10 MHz/1 MHz UP/DOWN operation
1
When the key is held down while in VFO mode, the
digit in the 10 MHz place in the frequency display starts
blinking. You can increase or decrease the value of the
digit by rotating the dial.
Display during 10 MHz UP/
DOWN adjustment
2
When the key is pressed
again, the digit in the 1 MHz
place starts blinking. You can
increase or decrease the value
of the digit by rotating the dial.