User Manual
8. Set Mode Congurations
61
8
8-2-10 Band Transition setting
When the setting frequency reaches the upper or lower end of the current
band during scanning or dial operation in the VFO mode, you can select
whether to return to the other end of the same band, or to move to the
next band.
1
Select Set menu No. 10, "bAnd".
The LCD should look like the gure on the
right.
2
Rotate the dial to select either
"ROTATE" or "ACROSS".
ROTATE Remain in the same band.
ACROSS Move to the next band.
8-2-11 APO function setting
APO stands for "Auto Power Off". When no operation is performed for
the specied time, a beep sounds and the DJ-X30 is automatically turned
OFF.
1
Select Set menu No. 11, "APo".
OFF
60min90min
30min
2
Rotate the dial to switch OFF
the APO function, or to select
the setting time. You can select
from 30, 60, or 90 minutes, and
OFF.
The LCD should look like the gure on the
right.
To turn ON the power again after it has benn turned OFF by the APO
function, hold down the [PWR] key again.
MEMO
• Any key operation can reset the countdown for the APO function and
extend the APO time. However, the APO time is not extended only by
signal reception.