User Manual
8. Set Mode Congurations
59
8
8-2-5 Lamp Operation setting
You can set the operation of the backlight of the LCD. Using the backlight
frequently increases the drain on the battery.
5-SEC
ALLOFF
OFF
ON
1
Select Set menu No. 5, "LAMP".
The LCD should look like the gure on the
right.
2
Rotate the dial and the backlight
operation changes as shown in
the gure.
OFF The backlight does not turn ON.
5-SEC When you operate the DJ-X30, the backlight turns ON
for 5 seconds.
ON The backlight continues illuminating.
ALLOFF The backlight and RX lamp do not turn ON.
8-2-6 Scan Type Switching setting
You can set the scan-resume condition.
1
Select Set menu No. 6, "SCAn".
The LCD should look like the gure on the
right.
2
When you rotate the dial,
the display changes from "BUSY" to a value between 1
and 25 seconds ("1-SEC" through "25-SEC").
"BUSY" indicates busy scan mode, and "1-SEC" through "25-SEC"
indicates the timer scan mode. Refer to the table below and select a
desired setting.
Busy scan
mode
After scanning stops, the DJ-X30 resumes
scanning when it receives no signal.
Timer scan
mode
After scanning stops, the DJ-X30 resumes
scanning after the specied time even though it is
still receiving signals.
This time can be set to any value from 1 to 25
seconds. (Indicated on the LCD as "1-SEC"
through "25-SEC")