User Manual

12. Reset Function
77
12
12-2 Default Settings
List of data after resetting (Factory default parameters)
Frequency VFO mode, 145.000 MHz
Volume level 20
Squelch level 3
Preset mode 76.1MHz
Scan VFO scan
Memory scan SINGLE scan
Tuning step frequency AUTO
CTCSS tone frequency 88.5
Set mode
Attenuator (ATT) function setting OFF
Earphone Antenna setting External antenna
AM Radio Bar-antenna setting ON
Shortwave Bar-antenna setting ON
Lamp Operation setting 5-SEC
Scan Type Switching setting Busy scan
Priority Channel selection 0 channel
Priority Monitoring interval setting 5-SEC
Priority Monitoring duration setting BUSY
Band Transition setting ROTATE (within the current band)
APO function setting OFF
Battery-save function setting ON
Beep deactivation setting ON
Bell function setting OFF
Monitor Key Operation setting PUSH
Monitor/Mute function setting MONI
Charging function setting OFF
Charging time setting 12 hours
Set Mode cancel time setting MANUAL
Write-protect (memory protection) function setting ON
Skip-scan Operation setting SKIP
Wild Key assignment setting ATT
Function assignment for Remote Controller
Button A
V/P/M
Function assignment for Remote Controller
Button B
BAND
Function assignment for Remote Controller
Button C
UP
Function assignment for Remote Controller
Button D
DOWN