User Manual

74
11. Cable-clone and PC Connection Functions
11
11-2 Receiving Data
Use the following procedure to copy data from another DJ-X30 or to receive
data edited on a PC.
1
Turn OFF the Slave and connect the stereo mini-plug
cable to its earphone jack.
Commercially-available 3-pole stereo mini-plug cable can also be used.
2
While holding down the [MONI]
key, press the [PWR] key to turn
ON the Slave.
"CLONE" appears on the LCD and the
Slave enters Clone mode.
3
Wait until the Master DJ-X30 or PC sends data.
4
When the data transfer nishes,
"FINISH" is displayed on the
LCD. Conrm the display and
turn OFF the Slave.
CAUTION
• The stereo mini-plug cable should be a direct-coupled type which
avoids internal resistance.
• While the Master is transferring data, pressing any key on the Slave
suspends the data transfer operation. To resume the operation, press
the dial.
• Do not unplug the cable while data is being transferred. Doing so will
suspend the data transfer operation, and "FAIL" will be displayed on the
Master's LCD.
• Note that the cloning procedure overwrites all data stored in the Slave
with the Master's data. Make sure that the Slave does not have any
necessary data.