Manualshelf

User Manual

ManualsBrandsAlinco Incorporated, Electronics Division ManualsElectronicsDJ-X30T Wide Band Communications Receiver
11121314151617181920
11. Cable-clone and PC Connection Functions
73
11
11.
Cable-clone and PC Connection Functions
The Cable-clone function copies data from one DJ-X30 to another DJ-X30.
By connecting two DJ-X30 units with a cable, you can copy the information
(including memory data) specied in the sending unit (herein referred to as “Master”)
to the receiving unit (herein referred to as “Slave”).
You can also edit memory channels and Set mode settings with free software
downloadable from Alinco's web site, by connecting the DJ-X30 to a PC using the
PC Connection function.
11-1 Cable Connection
Before connecting the cable, you must turn OFF the power of the DJ-X30.
Connect the earphone jacks on the Master and Slave with a commercially
available ø3.5mm stereo mini-plug cable. When you connect the DJ-X30 to a
PC, use the PC interface cable (sold separately; ERW-4C or ERW-7). Plug the
socket of the cable to the serial or USB port on the PC, and plug the other end
into the earphone jack on the DJ-X30.
●
4-pole stereo mini-plug cable
●
3-pole stereo mini-plug cable