User Manual
66
8. Set Mode Congurations
8
8-2-20 Write-protect (memory protection) function setting
You can enable editing (overwriting or deleting) for the channel data
programmed for the Memory mode.
1
Select Set menu No. 23,
"ProtCt".
The LCD should look like the gure on the
right.
2
Rotate the dial to switch between "ON" and "OFF".
ON Write-protect is enabled. You cannot edit the
programmed data in the memory.
OFF Write-protect is disabled. You can edit the data in the
memory.
To delete a memory channel, continue the procedure shown in "Deleting a
memory channel" (
+
P. ••).
CAUTION
• When you activate the Reset function while the write-protect function
is disabled, all data in the memory will be deleted. After you edit the
memory by disabling the write-protect function, be sure to activate the
function again.