User Manual

50
7. Useful Functions/Operations When Key Pad is Installed
7
7-5 Priority Monitoring Function
The Priority Monitoring function monitors two channels alternately, so that you
can catch signals of one frequency effectively while receiving the signals of the
other frequency. After receiving signals of the main channel for 5 seconds (*1),
the DJ-X30 monitors the priority channel for 0.5 seconds to see if there are any
signals being sent.
This function is useful when you set your favorite channel as a main channel,
and set a channel of interest as a priority channel.
1
In Memory mode, program the priority channel in
advance (
+
P. ••)
2
Tune to the main channel, and press the [FUNC] key to
display the icon on the LCD.
3
Press the
key.
"PRI" appears on the left of the LCD.
When the DJ-X30 monitors the priority
channel, the icon is displayed.
When the DJ-X30 receives signals on
the priority channel, a beep sounds. The
reception continues until the signals sent
from the priority channel stop (*2).
4
To cancel the Priority Monitoring function, press any
one of the [FUNC], , , or keys.
MEMO
• When no data is programmed to the priority channel, the Priority
Monitoring function is disabled.
• Scanning is disabled while the Priority Monitoring function is ON.
• The channel to be used for Priority Monitoring can be selected from the
bank for priority channels by using the "Priority channel selection" of the
Set mode (
+
P. ••).
• Since the DJ-X30 monitors the priority channel every 5 seconds (*1),
the audio of the main channel is momentarily interrupted at this interval.
Although this phenomenon is conspicuous in particular for constant
signals such as a broadcast, this is not a receiver failure.
*1 The interval at which the priority channel is monitored can be changed
in Set mode via the "Priority Monitoring interval setting" (
+
P. ••).
*2 The time for which priority channel signal reception is stopped can be
changed in Set mode via the "Priority Monitoring duration setting" (
+
P.
••).