User Manual

52
7. Useful Functions/Operations When Key Pad is Installed
7
7-7 Group Setting/Checking Function
During the Memory scan, the banks used for the scan can be grouped as
desired.
Up to nine groups can be set. Each group corresponds to keys through .
The following procedures are possible only when there are already programmed
memory channels in the banks.
7-7-1 Setting a group
1
Press the key to switch to Memory mode.
2
Press the
key to select a bank to include in a group.
3
Hold down the key of a desired
group number ( through
until "GRP-on" appears on the
LCD and the receiver beeps.
If the bank has already been included in the group, "GRP-of" appears and
the bank is excluded from the group.
4
To add other banks to the group, repeat the above steps
2
and
3
.
Example of group setting
To include banks 01 and 03 in group 5
(1) In Memory mode, select bank 01.
(2) Hold down the
key.
Check that a beep sounds and that "GRP-on" appears on the LCD.
If "GRP-of" appears, the bank is excluded from the group. In such a
case, hold down the key again to add the bank to the group.
(3) Select bank 03.
As in step (2), hold down the
key and check that "GRP-on"
appears.