User's Manual

50
8. Functions Assigned to the Key Pad
8
8-3 Switching the Modulation Mode
Select the modulation mode to use to receive signals manually.
1
Tune to the frequency you want to receive in advance.
2
Press the [FUNC] key to display on the LCD.

145.000
FM
VFO
BS
Modulation mode
Auto
3
Press the key to display
“Modulation mode” on the LCD.
4
Rotate the upper dial to switch
the modulation mode.
The modulation modes for the main band are switched as follows:
FM WFM CWAM USB LSBAuto
The modulation modes for the sub band are switched as follows:
Auto FM AM
CAUTION
• The modulation modes which can be selected for the sub band are AM
and FM only.
• Since the SSB/CW reception of the DJ-X11 uses a simple circuit, the
performance against interference or suppression is inferior to commu-
nication receivers, however, this is not a malfunction. Sometimes USB
can be demodulated with LSB depending on the signal strength.
•
The fi lter is common to CW and SSB and does not support the Narrow mode.
• To receive frequencies lower than the short wave band where SSB
and CW are frequently used, it is especially important to install an ap-
propreate external antenna.