User's Manual

Accessories

■Attaching and Detaching the Battery Pack

• Attaching

1.Align the projections on the

battery pack with the pits on

the transceiver.

2.Push in the direction of the

arrow until the latch clicks.

• Detaching

1.Push the latch upward.

2.Pull out the battery pack in

the direction of the arrow

shown left.

Caution

• The battery pack is not charged when shipped.

It must be charged before using.

• The battery pack can be charged by mounting it on the

DJ-C7 and connecting AC adaptor for charge of battery

to the DC power supply jack on the transceiver.

• It takes up to 2 hours and 30 minutes (maximum) to fully

charge the battery pack.

• Charging should be conducted within a temperature

range of 0 to 40˚C (32 to 104˚F).

• Do not modify, dismantle, incinerate, or immerse the

battery pack in water, as these practices can be

dangerous.

• Never short-circuit the battery pack terminals, as this can

cause damage to the equipment or lead to overheating

the battery, which could cause burns.

• Please be sure to remove the battery pack when the unit

is not in use.

• The battery pack should be stored in a dry place where

the temperature is from -20 to 45˚C (-4 to 113˚F).

• Typically, the battery pack can be charged up to 500

times.

However, the battery pack can be considered dead if the

period of use drops significantly despite the pack being

charged for the aforementioned charging time.

When this happens, a new pack should be used.

• In the interests of environmental protection, do not

dispose of the used battery pack improperly. Check with

your local solid waste officials for details on recycling

options or proper disposal in your area.

Latch

Projections

Pits