User's Manual

24
6
Parameter Setting Mode
6.3 Selecting the Parameters
The following 11 functions can be set in the DJ-C7's Setting
mode.
(1) Audio Volume Level
When you use an earphone, you may reduce entire volume
level with this function if the volume is too loud.
1. " " is displayed on the LCD.
2. Rotate the dial to switch HIGH/LOW of the volume
level as follows.
Caution
Never change the setting while you are wearing the
earphone. Your ear may be hurt with extremely loud noise.
(2) Antenna Type
You can select an antenna according to a frequency you wish
to receive.
You may choose an antenna type from the following options.
Bar antenna: The internal antenna which receives the
AM radio band and the Short Wave. You
are not allowed to exchange it to the other
antenna. Any settings are not necessary to
use this antenna.
Earphone antenna: The earphone's cord performs a role of an
antenna. The earphone antenna only
receives the FM radio broadcasts.
External antenna: You are allowed to use the helical antenna
attached to the DJ-C7 or any antennas on
the market. The external antenna receives
all frequency bands over 10 MHz.
1. " " is displayed on the LCD.
2. Rotate the dial to select an antenna between Earphone
and External (SMA) as follows.
(3) Repeater function
With this function on, you may activate a repeater easily and
quickly.
1. " " is displayed on the LCD.
2. Rotate the dial to switch ON/OFF of Repeater function.
When you set ON, " " will appear on the LCD.
When you set "AH" and "AL" as a pair of VFO auto programmed
channel in the Memory mode, a tone frequency and a value of
the Shift setting are applied automatically when DJ-C7 receives
signals from that range.
(4) Tone Burst Frequency
1. "1750" is displayed on the LCD.
2. Rotate the dial to select Tone Burst Frequency setting
as follows.
"1750" -> "2100" -> "1000" -> "1450"
"SmA" -> "EAr"
"HivoLUmE" -> "LovoLUmE"