User's Manual

Basic Operations

4.7 Receiving

1. Adjust a volume level. (See on P.XX)

2. Adjust a squelch level. (See on P.XX)

3. Select a frequency on which you want to receive

signals.

When a signal is received on the frequency you selected, the

BUSY icon will appear at the lower right on the LCD, and signal

level indicators are displayed according to the received

signals, as well.

Also, the green TX/RX indicator will light at the time.

■Monitoring

This function can be used to temporarily release the squelch

level setting you set only when the received signal is too

insufficient (weak) to monitor or is interrupted during

monitoring.

• The squelch is unmuted (is opened completely) while the

MONI key is held down, regardless of the squelch level

setting.

• This function unmutes (opens completely) the squelch even

Tone Squelch function is set.

4.8 Transmitting

1. Select a frequency on which you want to transmit

signals.

2. Press the PTT key.

When the red TX/RX indicator lights, it is now ready for

transmitting.

3. While holding the PTT key down, speak toward the

microphone on the transceiver at normal speaking

volume.

4. Release the PTT key when you finish speaking.

It returns to a receiving or monitoring state.

Caution

• Pressing the PTT key outside the transmission frequency

range displays " " on the LCD. Transmission is not

possible in this state.

• Especially, note that a receiving and a transmitting

frequency range differs when you set Shift direction

and/or Split setting.

Tip

Transmission available frequency ranges:

VHF... 144.000-147.995 MHz (DJ-C7T)

144.000-145.995 MHz (DJ-C7E)

UHF... 420.000-449.995 MHz (DJ-C7T)

430.000-439.995 MHz (DJ-C7E)