User's Manual

16
4
Basic Operations
4.6 Memory Mode
This mode allows you to program frequencies into the DJ-C7
memory. A programmed frequency is called as a channel.
The DJ-C7 has four types of memory functions; Memory
channel (general), Program scan channel, Priority channel, and
VFO auto programmed channel.
Types of Memory
Programming a Memory Channel
1. In VFO mode, adjust the frequency you want to
program by rotating the dial.
2. Set Shift (+/-) and/or Split settings, if necessary.
For more information on these settings, please refer to "Shift /
Split Functions" on P.XX.
3. Press the key to display memory channel number
on the LCD, and select a channel you want to write to
by rotating the dial.
The blank channels will blink and programmed channels will
stay lit up.
4. Press the key while the F icon appears on the
LCD.
A beep sounds telling that the frequency is written to the
memory channel successfully.
Tip
To overwrite to an already-exist memory channel, be sure
that Memory Write Protect function is set as "OFF". For
more information on this function, please refer to "Memory
Write Protect function" on P.XX.
Selecting a Memory Channel
1. Press the key to switch to the Memory mode.
A memory channel number will be displayed on the LCD.
Caution
When nothing is written as a memory channel, you may
not switch to the Memory mode.
2. Rotate the dial to select the memory channel number
you want to call up.
Clockwise rotation: Each click increases the memory
channel number by one.
Counter-clockwise rotation: Each click decreases the memory
channel number by one.
Memory channel
(general)
(0-199)
Program scan
channel
(OA, Ob-4A, 4b)
Priority channel
(PRI)
VFO auto
programmed
channel
(AH, AL)
This is a channel which is called up in
Memory mode. You may program up to 200
channels in the DJ-C7. When you program
frequently used frequencies in advance, you
can easily call up whatever you want to use.
This is a channel which is used for Program
scanning function. You can program up to 5
pairs of frequency ranges. (higher and lower
limits) (See on P.XX)
This is a channel which is used for Priority
monitoring function. (See on P.XX)
This is a channel which is used for Repeater
function. (See on P.XX) You can program a pair
of frequency range (higher and lower limit) to
apply settings for the repeater automatically.