User's Manual
4
Notice
.Compliance
Information
Statement
FCC WARNING
This equipment generates
or
uses radio frequency energy.
Changes
or
modifications
to
this
equipment
may
cause
harmful
interference
unless
the
modifications
are
expressly
approved in the
instruction manua
l.
The
user
could lose
the
authority
to
operate
this
equipment 汗 an
unautthorized change
or
modification is made
INFORMATION
TO
THE DIGITAL DEVICE USER
REQUIRED
BY
THE FCC
This equipment has been tested and found to comply with the limits for a
Class B digital device
, pursuant to Part
15
of
the FCC Rules
These
limits are
designed
to
provide
reasonable
protection
against
harmful
in
terference in a residential installation.
This equipment generates
, uses
and
can generate radio frequency energy
and
,
if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However. there is no
guarantee that the interference will not occur in a particular installation. If
this equipment
does
cause harmful interference to radio
or
television
reception
, which can be determined
by
turning the equipment off and
on
,
the user
is
encouraged to try to correct the interference by one
or
more
of
the following measures
• Reorient
or
relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to
an
outlet on a circuit different from that to
which the receiver is connected
• Consult the dealer for technical assistance.
CE
Conformity
Information
In case the unit you have purchased is marked with a CE
symbol
, a copy
of
relative conformity certificate
or
document
can
be
reviewed at
h
忧
p:llwww.alinco.com/usa.html.
•
RADIO
FREQUENCY
ENERGY
SAFETY
INFORMATION
Notice
This
Alinco
transceiver has been tested and complies with the standards
listed below
,
in
regards to Radio Frequency (RF) energy and electromagnetic
energy (EME) generated by the transceiver.
• FCC
RF
exposure limits for
Occupati
ο
nal
Use Only.
RF
Exposure limits
adopted by the FCC are generally based
on
recommendations from the
National Council on Radiation Protection and
Measurements
, and the
American National Standards Institute.
• FCC OET Bulletin
65
Edition
97-01
Supplement C
• American National Standards Institute (C95.1 - 1992)
• American National Standards Institute (C95.3 - 1992)
卢
Aw.
川咱
ThisAI
川
inco
transceiver generates
RF
EME while
t
廿
ra
门
smit
创
tin
、
g.
RF
EME
(Radio Frequency Electric and
Magnetic
Energy) has the potential to
cause slight thermal
, or heating
e
仔
ects
to any part
of
your body less than
the recommended distance from
this
radio transmitter's antenna. RF
energy exposure
is
determined primarily by the distance to and the power
of
the
transmi
忧
ing
device. In general, RF exposure is minimized when the
lowest possible power
is
used or transmission time
is
kept to the minimum
required for
consistent
communications
, and the
greatest
distance
possible from the antenna to the body
is
maintained. The transceiver has
been
designed
for
and
is
classified
for
Occupational
Use
Only.
Occupationall controlled exposure limits are applicable to situations in
which persons are exposed to RF
energy
as a
consequence
of
their
employment
, and such persons have been made aware
of
the potential for
exposure and can exercise control
over
their exposure. This means you
can use the transceiver only
if
you are aware
of
the potential hazards
of
operating
a
transceiver
and are
familiar
in ways to mi
nimize
these
hazards. This transceiver is not intended for use by the general public
in
uncontrolled environments. Uncontrolled environment exposul
re
limits are
applicable to situations
in
which the general public may
be
exposed to
RF
energy,
or
in which the persons who are exposed as a consequence
of
their employment may not be fully aware
of
the potential for exposure
or
cannot exercise
<:ontrol
over their exposure.
5