User's Manual
43
FUNCTION MENU SETUP
Tone Pulse Frequency Selection
This function is used for waking up sleeping repeater, it needs a certain intensity of Tone Pulse to wake up
sleeping repeater. In general, as long as the repeater has been waked up, no need to transmit Tone Pulse
again in preset time.
1. Press
key, the top left corner of LCD displays “ ” icon, then press key enter into function menu.
2. Press
/ key to choose NO. 29 function item, it shows “TBST” on LCD.
3. Rotate channel switch to choose desired setup.
1750HZ, 2100HZ, 1450HZ, 1000HZ, 4 kinds of Tone Pulse for optional
4. Press
key or key to conrm and exit.
Battery Save Setup
User can setup battery save ratio according to requirements. The standby time can be extended when
enable battery save function, but if save ratio setting too high, it may cause voice missing.
1. Press
key, the top left corner of LCD displays“ ” icon, then press key enter into function menu.
2. Press
/ key to choose NO. 30 function item, it shows “SAVE” on LCD.
3. Rotate channel switch to choose desired setup.
OFF: Battery Save is disabled.
1:2 The standby time between normal working state and battery saving mode is 1:2
1:3 The standby time between normal working state and battery saving mode is 1:3
1:5 The standby time between normal working state and battery saving mode is 1:5
1:8 The standby time between normal working state and battery saving mode is 1:8
AUTO: Battery save ratio is adjusting automatically.