User's Manual

SHORTCUT OPERATIONS

CTCSS/DCS Scan

Press key, the top left corner of LCD displays “ ” icon, press key to

enter into CTCSS/DCS scan. Under this state, rotate channel switch to change scan

direction. When scan the matching CTCSS/DCS signaling, it will stay 5seconds and

then go on scanning. Press any other keys except , , key to exit.

Offset Frequency Direction Setup

Under standby state, press key, the top left corner of LCD displays “ ” icon,

press key to choose offset frequency direction. There are 3 options, Positive

offset, Minus offset, shut off offset.

1. (+) Positive offset: Indicates TX frequency is higher than RX frequency. When

enable reverse function, the RX frequency is higher than TX frequency.

2. (-) Minus offset: Indicates TX frequency is lower than RX frequency. When enable

reverse function, the RX frequency is lower than TX frequency.

3. None: Indicates shut offset off.

Under frequency mode (VFO) or channel mode, press

key then press key to choose positive offset

direction(+), minus offset direction (-) , shut offset off one by one (Please refer to offset frequency setup).

NOTE: This function is unavailable in professional transceiver mode.

NOTE: This function is invalid when transceiver works in professional mode or the

main channel no setting CTCSS/DCS signaling.

In main channel, if signaling set as CTCSS, it will scan CTCSS, if sets as DCS, will

scan DCS.