User's Manual

3.Names and Operations of Parts
3
19
⑨

⑩
⑪

⑫
Power key
Keypad
Microphone/
Speaker jack
Dial
Press the power key down for approximately one second to turn
on/off the unit.
Refer to "Keypad" (page 20).
For an optional speaker/Mic connection.
Rotate the dial to select the frequency of operation, memory
channel, offset frequency, tone frequency, DCS code, Set mode
settings, and the characters for name-tags. Rotating the dial
while pressing the FUNC key increases or decreases the
frequency in 1MHz order.
①

②
③
④
⑤

⑥
⑦



⑧
SMA Antenna
Connector
PTT key
Speaker
Microphone
TX/RX lamp
Display (LCD)
FUNC key
MONI key
Attach the whip antenna. If you plan to use an optional antenna,
select one that is tuned to the operating frequency.
Press the PTT key to transmit, release to receive.
A speaker is built in.
Speak into the microphone from a distance of about 5cm (2").
Lights green when the squelch is unmuted. Lights red during
transmission.
Refer to "Display" (page 21).
The FUNC key is used in combination with the other keys to
access the various functions of the unit. To enter the Set mode to
set operating parameters, press the FUNC key continuously for
about 2 seconds.
When the MONI key is pressed, the squelch unmutes regardless
of the TSQ/DCS setting. Pressing the MONI key after pressing the
FUNC key illuminates display for about 5 seconds. Pressing the
MONI key while pressing the PTT key transmits a tone-burst signal.