Instruction manual

With the helicopter hovering, observe for any rapid left/right or forward/aft oscillations. If forward/aft oscillation is observed, land the
helicopter, turn the ELEgain dial counterclockwise gradually, and test again. Dothis until oscillation disappears.
$t~i§i:~tI!~~l?!rRrr ' 1l!~i§i:~tI!?:ctJ&im~~6'~:;FiE:%~~:t>lf1J~~, ~lili!im~~:t>lil1~~, llU~IJjjH~~rt~m£~~~~tlllm' ~~0-IlB!b'l!liim~~IE~~ °
Set the dial to 12 o'clock position as starting point
m~m~UI~D~~12Iiil1.J[i5j
Elevator gai;';~i'ljustment d:i:al·, -'~
7T.aelS!!.!llIIUIl~,,,,, :'h%'"~i/' ,;
Decrease ELE gain
I!I~ELESM
Forward/back oscillation
im~3Uh
If left/right oscillation is observed, land the helicopter, turn the AIL gain dial counterclockwise gradually, and test again.
Do this until oscillation disappears.
110lili!~?:ctJf-If1J' ~1Jjj~t~~~U.~~1JIl~~m' ~jJ9Ii0-~B@;ii?:ctJi~IE~~ e
Set the dial to 12 o'clock position as starting point
m~ID~UftD~~12!oilD[i5j
Aileron;gain adjustment dial -_ :
~R.!!.~~m '
Decrease AIL gain
IlI~AIL@lM
AOOOOOOOO FC!rwa~dFlight
~ imiirRh
Using Futaba 12ZH transmitter as an example ~Fataba 12ZH.~R~~J
With emphasis on stability
With emYlasis on agility
.~mf
]5~tt
Main blade pitch Settings(Coliective Pitch Settings)
Main blade pitch: 10°-12°
Main blade pitch: 12°-14°
~~H@;~e: 10°-12° ~~H@;~e: 12°-14"
=E1lOIIRI!eU (.ItHB!!:~)
swash pitch: 38%-44% swash pitch : 44%-50%
Cyclic pitch settings
Cyclic Pitch 1 O· i1§~@;~10°
Cyclic Pitch 12° ~lil1lllf:~e12°
(Adjust while in DIR mode using AILIELE swash AFR)
swash Aileron : 65%
swash Aileron: 75%
MIftHU (~ttDIR~""F!!t~)
Elevator : 65%
Elevator: 75%
Aileron and Elevator swashplate mixing ratio settings
swashAileron : ~65%
swash Aileron : ~ 75%
IJIUmMllUliI*U
Elevator: ~65%
Elevator : ~ 75%
Aileron and Elevator gyro gain settings 12 o'clock direction(50%)
11 o'clock direction(40%)
IJ.mt~mem~M!!t~
12fOil1.J[qj(50%)
11fO~1.J[qj(40%)
,
..
While In DIRsetup mode, the transmitter s CCPMswash mixing values for aileron and elevator represent CYCLICpitch
values. These values affect the cyclic roll rates on the aileron and elevator in flying condition. Higher values translate
to faster cyclic roll rates. If cyclic roll rate is not improved with Increased swash mixing values, this is due to
insufficient cyclic pitch. When this happens, cyclic pitch can be increased through the flybarless setup procedure.
Maximum cyclic pitch should be limited at 14degrees.
ji~;3§Lfl'jJCCMP+~Il)f!l~SWASH~"DIR"~:tC~J:E~lji~~1Jjj, Aileron~Elevatortt~j@:fl'jJ1\.IJ\M~~~~~~fl'jJ1\.IJ\, tt~~~~lil1~~e
fl'jJ~~w1\.: ffili'±rRrr~:tCl'Aileron~Elevatortt~j@:fl'jJ1\.IJ\MjtU5~~fl'jJ1\.IJ\' tt~w~iR.~~Jal~ , j§:stt~rJill~j}J1!!{$jjHtiR.~~~
~~i1§li~£nel'.lE ' ~ii.i\1!!{.lfIitiiUf~~~J:E~:tC' ~jI§~~l@J01\.,j§~1'~~14 o~~ °
39