Instruction manual

5. A.REV aileron reverse setup mode:
A.REV 1J.1IB•• iE§Rlm~.lt :
Press the SET button to enter A.REV setup mode. The A.REV LED
will lit up after A.LlM turns off. Tilt the helicopter right as shown
in diagram, and check if swashplate is tilting correctly toward the
left. If the swashplate is tilting at the wrong direction, move the
transmitter aileron stick until STATUSLED changes color, and
re-check the swashplate tilting direction. Press the SET button
again, and the control unit will restart with all LED's flashing.
This completes the flybarless portion of the setup process.
m~mT'SET"m ' iR~~~~5\liJ\"A.REViiiU.Il'8~iiiIE&iOJ"8l!:~~:IC ' Jlt~
A.LlMm~j£ , A.REVm~Jte • Jlt~:IC8l!:~iiiU.ll'8~iii~IE1.JiOJ' ~~~~~ft
t±:o~ ' 3GXFlybarlessBi~+~~iOJ~~~IE ' !/O~&iOJ' ~iOJ~~iOJ:O:J!Ei1J
iiiUHm~ ' ~~ "STATUS"1'15.I~~m~ ' !l!~Il'8~lif~IE1.JiOJ •
m~mT'SET" m~px~!!p:p:~H*m8l!:~ ' pfT~LED~r;.'jJ1J' ~Wflmft •
Helicopter tilting
~ direction
~ lI.fU!:01i'!J
Swash plate correction
direction
+~M!{fiE:01i'!J
3GXFlybarless system must remain stationary
during startup. Do not move the helicopter
until the swashplate jumps up and down
slightly 3 times, indicating the completion
of initialization. (please refer to page 35 step 3)
3GX Flybarless IlIItIi'IlJ!ifi~l\WYil{~ • !ltIJ!i~IlJII§ .
SWYilH:.~Atm· +~M!~~*ljZ..trc/J~3:;J(· i'<jf-1lII
tIi'I~At· (~~35j;[*1l3)
A.REV settings
A.REV~'st
Helicopter tilting
direction ~
lI.m~:o1i'!J ~
OOLpDER"GYRgch§.ELLJe ..•••Il~ •.• ~_ .•.•. ±Ilil ~,
After the system reboots, flybarless setup is completed. Now the rudder gyro needs to setup witti simjlar
GP780 gyro. Push and hold the SET button for 2 seconds to enter the rudder gyro setup moa
If your transmitter has the following settings, please disable it or set the value to"Zero.
~PXlmftW:FlybarlesslS!l7Jo88l!:~~PX ' m~~8l!:~~~Il'8.iii ' PfT~8l!:~~I5.IGf!780• ~mft:tAmr::~sET~ftJ>~J\~ft8ilB~iii8l!:~ •
~~11I18'illi~~~r::9UJ}Jtre~ ' ~8l!::@1Imrmf1l:l(OFF)~rxm8l!::@1Im~•
• ATS • Rudder to gyro mixing
• Pilot authority mixing • Pitch tcutftlder ~lxin9
• Throttle to rudder mixing • Revolutiontmixiirl9
0"1:.
3GX Flybarless rudder gyro has the factory:settirw of 1520# andDS digital servo. Double check your servospec an
change the gyro setting as needed to avoid damag s to the servo.
3GXFlybarless~~JI'8l*lMfll~:@i~1Im : 1520~ S~~DSmllifqJIl&Htt ' ~~Ifij~~~11I18'ilfqJll&~m~ ' H8l!::@i~l'l5.Iilii~pxfqJlHll§~~ •
1.1520 f.l. s (standard) or 760 f.l. s(narrow band) servo.frame-tate setup.
1520 u s (.~)~~&-oiJ. s (~.)~BI.It~
3GX Flybarl ystem;i~'compatib1~ with D()]Jthe,.:760 f1 s narrow frame rate servos (such as Futaba 59256, 59251, BLS251),as well
as the stand 5~0.Jls"frame rate s rvos (most others). Proper frame rate must be selected based on your servo's specifications.
To enter the setup mo e : Press and hold the SET button for 2 seconds until STATUS LED flashes. The 1520/760 LED will
light up indicating servo frame rate..setup mode. Push the transmitter rudder stick left or right to select the frame rate. For
example, if liudder is pushed 0 tile left (or right) and STATUS LED turns green, the frame rate is set to 1520 f1 s. To set it to
760 u s, the rudder stic nee.dto be pushed from the center to the opposing end 3 times for the STATUS LED to turn red, indic
ating frame rate se~ 0 I 0 f1 s. .
3GX Flybarlesspanel: Each setting value is labeled on the 3GXf1ybarless control unit with either green or red lettering,
which corre$P!l"ds to the STATUS LED color. Subsequent setup mode is entered by a single press of the SET button.
Setup mode~i11 exit if no activity is detected in 10 seconds.
3GX Flybarless;f§~~H~~)EtI:JSgffiiJ*m' ~11I1flEm8'ilfqJHIil~.l%760 u s*m (!/OFutaba S9256 , S9251 ,BLS251) ,
fliJ~\~~3GX Flybarless~:@l%7608'il~:IC ' JtIt!!*~5j'(760 ~sm~8'iliQ)HIil~' -!tit~1Im1520 u s**1t ' ~~~1Im 15208'il~t\ •
~J\J;lJJg!U~.it : ~mi§j~..t8'il"SET"8l!::@mMiJ2li»• Jlt~"STATUS":tAlmfej5j'(m~rm~r;.'j~' .§"15201760·8'ilJ}JIlli~~fej5j'(m~~m ' ~5j'(~J\~$/
~~fqJHIR~~:ij1j, fUmli~~1.JiOJ~m~8'il~£1.JiOJ*~li~~i~' i91J~1.JiOJft8m~t±~ (~:o) ~"STATUS'fej5j'(m1lmiolk~' ~5j'(&l::@f@:1Im1520~s*
m ; ~~~~1Im~~760 ~ s*m~ ' ~\~~m~EI3£tlrr!iit±;f§.&1.JiOJi.I.lBllJ~ ' flE"STATUS"fej5j'(m!ffin~' ;t~liJ\760 ~s*m •
3GX Flybarless9Slilii~ : ~m..t8flEmiolk/n~8'il~e~5j'("STATUS"m~pfTf~~8'il&l::@f~· 8l!:JE~pxW:W'SET"m-~~~J\ r::-flQl~~' ~~10li»PH
iO'Xf~@~:@, **1C~§J1J~Im8l!::@~:IC•
Green LED : 1520,usstandard band
Red 1.1:0 : 760,u s narr.owband
~~m : 1520 11sii:MijqJD&~
~..,{[m: 760 us~MijqJD&~
" Select by moving the rudder stick left and right
a::O.~1.Jll!Iae ••
RUD
29