Instruction manual

'
Apply a little amount ofT43 thread
lock whenfixing a metalpart.
iU\\II'lJll!l~iiI.f!1:III«!!!!lHT43(i1U)
When tightening the main blade fixing screw, please tighten it firmly,
but not over tighten, or it may cause the damage of main blade holder
and result in danger.
~~~~M.~~~~~~~MW~'~~~~ •• ~~H.~.m,mB~~~~·
Standard Equipment:
Main shaft spacer(1)
1l$1i8' ~ilJllmF'1(1)
4>12x4>16x1mm
Spare part: Main shaft spacer(1.2)
Main shaft spacer(O,8)
Main shaft spacer(O.5)
fMli8'~ilJllmi'1(1.2) 4>12x4>16x1.2mm
~filmF'1(0.8) 4>12x4>16xO.8mm
~Q!!F'1(0.5) 4>12x 4>16xO.5mm
Before fastening the M4 set screw, make sure the motor pinion gear
is contacted with the bearing in the motor gear case downward.
~iI~&!J'iJl'rnjUli!ii~&!~I!ajj'(~. j!ij~4.Itj§!tUUI'!~•
690 3G Carbon Fiber Blades
690 3G !iIl1I1UM
[ 700FLH3A I
@
DL------
Socket collar screw
IIMP3/~Q8.~(M5x32mm) x 2
M5 Nut
M51\lJ~.'~ x2
Main shaft spacer(1) Spare part:
~Q!!i'1(1)(4> 12x4>16x1mm)x 1 Main shaft spacer(O.8)
.50 ' ±fHll!!i'i(Q.S)
($12x$16xO.8mm) x 1
o~o
Spare part:
Main shaft spacer(O.5)
tlli8 ' ~ilJllmi'1(0.5)
(4) 12x 4>16xO.5mm) x 1
Spare part:
Main shaft spacer(1.2)
f/i!88 '~ilJllmF'1(1.2)
(4) 12x4>16x1.2mm) x 1
M1 Slant thread main drive
gear set
M1~~aIUI
~ .-., Socket screw
M4 Nut ~-- ll'!liiIlf'9j\fi'3i1J11g.~
M41\lJ~.m 1700 FLZ4A I M4x27mm
cQD:J
17
Ball link
iI~llf!x4
1 700FLZ41
o
Linkage rod(D)
i!~(D)( 4>1.96x39.5mm) x 2