User`s manual

3.2.9 Remote Access Configuration

Remote Access

Selects remote Access type. When enabled, parameters appear for configuration.

[Options are: ‘Enabled’ and ‘Disabled’]

Serial port number

Selects the serial port to be used for console redirection.

[Options are: ‘COM1’ and ‘COM2’]

Serial port mode

Selects the Serial port settings.

[Options are: ‘115200 8,n,1’,‘57600 8,n,1’,‘38400 8,n,1’,‘19200 8,n,1’,‘09600 8,n,1’]

Flow control

Selects the Flow Control for console redirection.

[Options are: ‘None’, ‘Hardware’ and ‘Software’]

Redirection after BIOS POST

Determines for how long the redirection to the serial port chosen above will take place

during the POST. Disable will turn off redirection after POST. Boot Loader will activate

redirection during POST and during Boot Loader only. ‘Always’ will activate redirection

all the time, but might cause some OSes to stop booting.

[Options are: ‘Disable’, ‘Boot Loader’, and ‘Always’]

Terminal Type

Selects the type of terminal determined for target.

[Options are: ‘ANSI’, ‘VT100’ and ‘VT-UTF8’]