User`s manual

3.2.4 SuperI/O Configuration

Onboard Floppy Controller

Enables or disables the floppy controller.

[Options are: ‘Enabled’ and ‘Disabled’]

Serial Port1 Address

Selects the base address to use for the Serial Port1.

[Options are: ‘3F8/IRQ4’, ‘3E8/IRQ4’, and ‘2E8/IRQ3’]

Serial Port2 Address

Selects the base address to use for the Serial Port2.

[Options are: ‘2F8/IRQ3’, ‘3E8/IRQ4’, and ‘2E8/IRQ3’]

Serial Port2 Mode

Selects the mode in which Serial Port2 will function.

[Options are: ‘Normal’, ‘IrDA’, and ‘ASK IR’]

IR I/O Pin Select

This setting appears when Serial Port2 Mode is set to IrDA or ASK IR. It will let the BIOS

select Receiver or Transmit pin.

[Options are: ‘SINB/SOUTB’ and ‘IRRX/IRTX’]

IR Duplex Mode

This setting appears when Serial Port2 Mode is set to IrDA or ASK IR. It will let the BIOS

select IR transmission mode.

[Options are: ‘Full Duplex’ and ‘Half Duplex’]

Parallel Port Address

Selects the base address for the Parallel Port.

[Options are: ‘378’, ‘278’, and ‘3BC’]