Instruction manual

66
Click OK to save setting. A confirmation message will appear on the screen asking you to
reboot the DVR. Click Yes to reboot.
After the system has rebooted, re-enter the Camera Management menu and continue with
the following steps.
4. Select the Add button to enter IP Channel Settings menu, shown below.
5. Select the IP device from the list. The devices found in the list are those supported by
SADP and are found by the DVR. If no devices were found, you may manually enter the
camera parameters in the fields below.
6. Enter IP camera parameters. This includes the IP address (domain name), manage port,
channel port, manufacturer and password of the IP camera.
7. Select OK to save and return to the Camera Management menu.
8. If IP camera was added successfully, the Status for that camera would show that it is
Connected. If it does not, click the Set button to verify that the parameters were entered
correctly. You may also delete an added channel by clicking the Delete button.
Intelligent Security and Fire Ltd