Instruction manual

61
2. Select channel where PTZ camera is installed next to Camera label.
3. Enter PTZ settings so it matches that of the PTZ camera.
4. Click OK button to save and exit menu.
9.3 Setting PTZ Presets, Patrols & Patterns
Your DVR allows you to customise presets, patrols and patterns for a connected PTZ
camera.
9.3.1 Understanding PTZ Controls
Before setting presets, patrols and patterns, it’s important to understand some of the
features of the PTZ control panel, shown below.
The controls on the PTZ panel include:
1. Directional Pad/Auto-scan Buttons: Controls the movements and directions of
the PTZ. Center button is also used to start auto-scan of PTZ.
2. Zoom: Used to zoom in and out with the PTZ.
3. Focus: Used to adjust the focus of the PTZ.
4. Iris: Used to open up or close the iris of the PTZ.
5. Speed: Adjusts the movement speed of the PTZ.
6. Light: Turns PTZ light (if applicable) on and off.
7. Wiper: Turns PTZ wiper (if applicable) on and off.
8. Zoom In: Instantly zooms PTZ in.
9. Center: Centers PTZ.
9.3.2 Customising Presets
Presets can be set to move your PTZ camera to a desired preset location at the click of a
button. To setup and use custom PTZ presets:
1. Enter the PTZ Control interface, shown above by clicking PTZ in the mouse
menu or the PTZ button on the front panel.
2. Select the Preset button to enter the Preset Management menu.
3. In the Preset Management menu, shown below, you may:
• Configure Preset: Use the PTZ control panel to adjust the position of the preset. Select
a Preset number and click the Set button to save preset location.
• Clear Preset: Select a Preset number and click the Clear button to delete the preset.
You may also select the Clear All button to delete all presets.
• Call Preset: Select a Preset and click the Call button.
Note: Only valid presets can be called and deleted.
Intelligent Security and Fire Ltd