Instruction manual

• Audio Warning: Triggers an audible beep when exception is detected.

• Notify Surveillance Centre: Sends a signal to remote alarm host when exception is

detected (See Configuring a Remote Alarm Host).

• Trigger Alarm Output: Triggers an alarm output when exception is detected. Alarm

output can be configured by following the steps listed in Setting Up Sensor Alarms.

• Send Email: Sending email when exception is detected. Sending email can be

configured by following the steps listed in Configuring E-mail Settings.

8. Network Settings

8.1 Configuring Network Settings

Network settings must be configured before you’re able to use your DVR over the

network.

8.1.1 Configuring Basic Settings

To configure basic network settings:

1. Enter the Network Settings menu shown by clicking Menu > Setting > Network.

2. Select the General tab.

3. If you have a DHCP server running and would like your DVR to automatically obtain

an IP address and other network settings from that server, check the DHCP checkbox.

You may check the DHCP status by going to the Network Status tab, as shown below.

Intelligent Security and Fire Ltd