Instruction manual

53
7.2 Setting Exception
Setting exceptions allow the DVR to alert you when irregular events occur. These events
include:
• HDD Full: All installed HDDs are full.
• HDD Errors: Errors occurred during writing of the HDD, no HDD installed
or HDD has failed to initialise.
• Network Disconnected: Disconnected network cable.
• IP Conflict: Conflict in IP address setting.
• Illegal Access: Wrong user ID or password used.
• Video Exception: Unstable video signal detected.
• Video Output Standard Mismatch: I/O video standards do not match.
• Abnormal Recording: HDD not recording.
To set exceptions:
1. Enter the Exception menu by clicking Menu > Exception.
2. Select the exception to configure Exception Type.
3. Select triggering options, as shown below. Trigger options are further
explained in the next section (See Understanding Exception Trigger
Options).
4. Click OK to save and exit Exception menu.
7.2.1 Understanding Exception Trigger Options
When setting up exception handlers for such features as motion detection and sensor
alarms, you may select triggering options to alert you of these exceptions.
The triggering options that you may select include:
• Pop-up Image on Monitor: When an alarm is triggered, the local monitor
(VGA or BNC monitor) will display an image under Live Preview mode. This
alarm can be configured under the Popup Alarm Image handle method. For
alarms that are triggered simultaneously, images will be displayed one at a time
every 10 seconds (default dwell time). A different dwell time can be set by going
to Menu > Setting > Display > Dwell Time. Once the alarm stops, cycling of the
images will also stop and you’ll be returned to the Live Preview screen.
Intelligent Security and Fire Ltd