Instruction manual

38
2. Set Start Time and End Time.
3. Click the Search button.
4. A list of results with your search criteria will be returned. Select the video
log to playback and click Play. An Attention message will be displayed if there
is no video associated with the log.
5. The recording will begin to play in the Playback interface.
5.6 Playing Back Frame-by-Frame
To playback frame-by-frame in the Playback interface:
• Using a Mouse:
1. Click the Slow Forward button on the Playback Control Panel until the
speed changes to Single frame.
2. Click the Pause button to advance the video frame by frame.
• Using the Front Panel/Remote:
1. Rotate the inner control on Jog Shuttle counterclockwise or press the Down
button to set the play to Single frame.
2. Press the OK button.
3. Press the Enter button to advance the video frame by frame.
5.7 Smart Search
In order to locate a motion detection event easily and accurately in the playback progress
line, users are allowed to analyse a certain area (scene) dynamically, and to get all of the
related motion detection events that occurred in this area.
Note: The smart search function is only available for analogue channels. To use dynamic
analysis function:
1. Go to playback interface and play the video
2. Right-click mouse and select Dynamic Analysis to go to analysis area selection
interface
3. You can left-click the mouse and drag an area for motion detection analysis, then
right-click mouse for display menu shown below.
Intelligent Security and Fire Ltd