Instruction manual

6. Select the day you would like to setup the schedule for or select All Week to record the

entire week.

7. Select to record the entire day by clicking All Day or at different time periods. Up to 8

time periods can be scheduled. It is important to note that time periods must be

consecutive and must not overlap.

8. Select recording Type. Recording type can be based on time and triggered by motion

detection and/or alarm. Motion detected and alarm triggered recordings are further

explained in Configuring Alarms.

9. Click the OK button to finish configuration.

10. Repeat steps 3-9 for other cameras or copy settings from one schedule to the next

under the Copy To section.

11. Click OK to finish and save the schedule settings.

Note: Event encoding parameters take effect when motion detection or alarms are

triggered. Normal encoding parameters take effect without any events triggering.

4.1.3 Starting a Manual Recording

4.2 Protecting Recorded Files

There are two methods to prevent recorded files from being deleted off the HDD. It’s

highly recommended that important recorded events be protected from deletion.

Recorded files can either be locked or the HDD that the files reside on can be set to read

only.

4.2.1 Locking and Unlocking Recorded Files

To lock or unlock a recorded file:

1. Enter the Video Search menu by navigating to Menu > Video Search. The Video

Search menu is shown below.

A manual recording can be started at any

time. To start a manual recording:

1. Press the REC/SHOT button on the

front panel or in the Main menu to bring

up the Manual Record menu shown to the

right.

Start manual recording by selecting On

or Off for the cameras desired.

Intelligent Security and Fire Ltd