Instruction manual

27
3.3.2 Channel Zero Encoding
Sometimes the user needs to remotely view a number of cameras simultaneously through
the web browser or client software on limited broadband resource. The Channel Zero
feature allows a number of different channels using various display formats to be viewed
(the Channel Zero feature is a mirror image of the Main CVBS output settings) within
one channel display area using minimal networking resources. The Channel Zero
Encoding feature supports this option.
The following steps will detail how this function is setup.
1. Enter the Display Settings menu and select Channel Zero Encoding tab, shown below.
Note: Channel Zero does not support substream; only mainstream is available.
2. Enable Channel Zero Encoding by clicking on check box.
3. Set a frame rate bearing in mind that this option is primarily for networking over a low
resource Broadband. Recommend low frame rate e.g 1FPS.
4. Set maximum bit rate. Again set low value e.g 96Kbps.
5. Configure the Main CVBS settings to reflect required display settings, as this will be
the Channel Zero display in client software or web browser.
Client Software
6. Add an extra channel on DVR setup to show Zero Channel e.g 5 channels on a 4
channel DVR.
Intelligent Security and Fire Ltd