Instruction manual

1.4.1 If the remote controller does not operate the DVR

Aim the remote control at the IR receiver located at the front of the unit to test operation.

If there is no response:

1. Using the front control panel or the mouse, go into Menu > Settings > General > More

Settings.

2. Check and remember DVR ID number. The default ID number is 255. This ID number

is valid for all IR controls.

3. Press the DEV button on the remote.

4. Enter the DVR ID number from step 2.

5. Press the ENTER button on the remote.

If the Status indicator on the front panel turns blue, the remote control is operating

properly. If the Status indicator does not turn blue and there is still no response from the

remote, please check the following:

1. Batteries are installed correctly and the polarities of the batteries are not reversed.

2. Batteries are fresh and not discharged.

3. IR receiver in DVR is not obstructed.

1.5 Using a USB Mouse

A regular 3-button (Left/Right/Scroll-wheel) USB mouse can also be used with this

DVR. To use a USB mouse:

1. Plug USB mouse into one of the USB ports on the front panel of the DVR.

2. The mouse should automatically be detected. If in a rare case that the mouse is not

detected, please refer to the recommended device list from your provider.

The buttons on the mouse corresponds to:

1. Left Button

• Single-Click: Select a component of a menu, such as a button or an input field. This is

similar to pressing the ENTER button on the remote/front panel controls.

• Double-Click: Switch between single screen and multi-screen mode in Preview/

Playback mode.

• Click and Drag: Clicking and dragging the Left mouse button can be used to control

the pan/tilt of a PTZ camera as well as to vary the position of digital zoom area and

camera OSD. It can also be used to setup the alarm areas.

2. Right Button

• Single-Click: Shows pop-up menu.

3. Scroll-Wheel

• Scroll Up: In Preview mode, scrolling up will switch to the previous screen. In Menu

mode, it will move the selection to the previous item.

• Scroll Down: In Preview mode, scrolling down will switch to the next screen. In Menu

mode, it will move the selection to the next item.

Intelligent Security and Fire Ltd