Setup guide

39
Select Camera
Use the up and down arrow keys to select the appropriate channel.
Stream Type
There are two options Audio&Video and Video. Select Audio&Video if you
want both audio and video otherwise select Video only. You must reboot unit
to make this parameter effective.
Resolution
The DVR uses resolution settings, CIF, 2CIF and 4CIF (D1). When using 2CIF the frame
rate is reduced to a maximum of 12FPS and if 4CIF is selected the frame rate is reduced to
6FPS. If the resolution is changed you will need to reboot the DVR.
Frame Rate
The required frame rate can be selected from the following settings:
1, 2, 4, 6, 8, 10, 12, 15, 16, 18, 20, 22 and 25. For low frame rate you can
select low bit rate size. The bit rate is automatically set according to the frame
rate selected.
Bit Rate
If you select bit rate, the maximum bit rate must be limited when there are data
recording peaks. The bit rate is therefore associated to the frame rate selected.
The following options can be selected: 32K, 64K, 128K, 192K, 256K, 320K,
384K, 512K, 640K, 768K, 896K, 1Mbps, 1.25Mbps, 1.5Mbps, 1.75Mbps,
2Mbps and By User define. For CIF resolution the typical maximum bit rate is
384K ~ 768K.
Image Quality
This is set in the software and is not adjustable in the DVR. There are six
quality settings: Highest, Higher, High, Average, Low and Lowest. High
image quality needs a high bit rate size.
Enable Rec
Enable or disable camera record function by changing X meaning disable to
tick for enabled. When enabled the Schedule option is available.
Schedule