Setup guide

12
Loading the batteries in IR Controller
1. Remove battery cover.
2. Insert battery ensuring polarity correct.
3. Replace battery cover.
Start the IR Controller
Aim the IR Controller at the front of the DVR standing a few feet from the unit.
Press DEV key and input the DVR I.D (default is 255 but can be changed in the
Display Menu and then press ENTER key. Check that the IR Status light is displaying
Green). Note that in some models the DVR I.D default may be set to 88.
Stop the IR Controller
When the IR status is on, press the DEV key again to turn off the IR Controller. The
status lamp will now switch off and the IR Controller will not operate the DVR.
Switching the DVR off
When the IR Controller status is on, press the POWER key for several seconds and
the DVR will power off.
Troubleshooting the IR Controller
If the IR Controller does not operate the DVR then check the following items:
1. Check battery connections
2. Check battery charge
3. Check there is nothing covering the DVR IR sensor.
4. Check I.D in Display menu to see what has been set as default. Use this I.D to setup
IR Controller or change the value in the Display menu and use that by pressing DEV
key, entering I.D and pressing the ENTER key on the IR Controller.
5. Check that the IR Status light on the front of the DVR is displaying Green.