Owner manual

13
INPUT SIGNALS
Analog Input Signal
Apply analog input to Pin 4 as shown on page 12.


Standard 0-5 Vdc
signal to pin 4, with common ground on pin 8.

applied to pin 4, with common ground on pin 8.

applied to pin 4, with common ground on pin 8.
NOTE:
ohm resistor to ground.
NOTE:
CAUTION! 



Gauges:
7
6
5
4
3
2
1
8
5.12 Vdc
50 KOhm
Potentiometer
0-5 Vdc
Controllers
4
8