User manual
65ALI-NVR5000P Embedded NVR User Manual
SECTION 5
PTZ Controls
5.1 Conguring PTZ settings
Follow the procedure to set the parameters for control of a PTZ camera installed in the system. Setup of the PTZ parameters should
be done before you control the PTZ camera. This feature is only supported for PTZ capable cameras in the compatible cameras list.
See “APPENDIX D NVR Compatible Cameras” on page 168.
Check that the PTZ and the NVR are connected properly through RS-485 interface.
1. Open the PTZ menu. Go to: Menu | Camera | PTZ
2. Choose the camera for PTZ setting in the Camera drop down list.
3. Enter the parameters of the PTZ camera. All the parameters should be exactly the same as the PTZ camera parameters.
4. Click Apply to save the settings.
5.2 Setting PTZ presets, patrols and patterns
NOTE
The presets, patrols and patterns you congure must be supported by the PTZ protocols.
5.2.1 Customizing Presets
Follow the steps to set the Preset location which you want the PTZ camera to point to when an event takes place.
1. Open the PTZ settings menu. Go to: Menu | Camera | PTZ | More Settings
SECTION 5: PTZ CONTROLS