User manual

13ALI-NVR5000P Embedded NVR User Manual
2. Remove the NVR top cover. See “APPENDIX C HDD Installation” on page 167 for instructions.
3. Locate the jumper associated with the alarm output you are using for an AC load alarm, then remove it. Save the jumper for
use later, if needed.
4. Reinstall the NVR top cover.
DC load alarm output circuits
DC loads must operate within the limitation of 12V/1A. To connect to a DC alarm output, use the following diagram:
AC load alarm output circuits
To connect an AC load to an alarm output, a jumper, associated with the output on the alarm termination PC board, (within the
chassis), must be removed. These jumpers shunt pin pairs J1, J2, J3, and J4 for alarm outputs 1, 2, 3, 4 respectively. Use an external
relay for safety.
2.4 Install a monitor, mouse, power
For the following steps, refer to the back panel photo above for the location of connectors.
1. Install and setup your monitor in accordance with the instructions provided with the monitor. Do not power it on at this time.
2. Cable the HDMI or VGA connector to your monitor’s VGA or HDMI input. The HDMI interface provides the best performance.
SECTION 2: INSTALLING THE SYSTEM