User manual

170
APPENDIX C: HDD INSTALLATION
6. Set the HDD in a bay in the chassis as shown below for HDD 4, with the HDD connectors toward the back of the chassis. Align
the mounting screw holes on the underside of the HDD with the screw holes in the bottom of the chassis.
7. While holding the HDD in place in the chassis, carefully turn over the HDD together with the chassis and install the four HDD
mounting screws provided to secure the HDD in place. Tighten the screws until snug. Be careful not to overtighten the screws.
8. Turn the chassis top side up and verify that the HDD cables connectors are seated properly at both ends.
9. Install additional HDDs, as needed, following steps 4 - 8 above.