User manual
149ALI-NVR5000P Embedded NVR User Manual
SECTION 9: SYSTEM MAINTENANCE
a. Set the Work Mode as Hot Spare mode.
b. Click Apply, then click Yes to the Attention notice to reboot the NVR.
9.7.2 Setting the Working device
After rebooting the NVR in the previous step, do the following.
1. Open the Hot Spare menu. Go to Menu | Conguration | Hot Spare
2. In the Hot Spare menu, do the following:
a. Set the Work Mode as Normal Mode (default).
b. Check the checkbox of Enable to enable the hot spare function. See above.
c. Enter the IPv4 address and admin password of hot spare device.
d. Click Apply to save the settings. The Working Status should indicate Connected.