User manual
143ALI-NVR5000P Embedded NVR User Manual
SECTION 9: SYSTEM MAINTENANCE
b. Open the Device Name drop down list and select the device that contains the rmware.
c. Click the rmware le you want to load.
d. Click the Upgrade button, the follow the on-screen instructions for completing the upgrade.
4. If installing rmware from a FTP server:
a. Click the FTP upgrade tab at the top of the menu.
b. Click the rmware le you want to load.
c. Click the Upgrade button, the follow the on-screen instructions for completing the upgrade.
5. Open the System Information screen and verify that the new rmware version is installed.
9.5 Default
The default option will reset the NVR to its factory settings. Except the network parameters (including IP address, subnet mask,
gateway, MTU, NIC working mode, default route and server port), all other conguration parameters are restored to factory default
settings.
To restore the factory default conguration:
1. Open the Log Information menu. Go to Menu | Maintenance | Default
2. Click OK, then allow the NVR to reboot before continuing.
9.6 Net Detect
9.6.1 Checking Network Trac
You can see real-time information of your NVR network trac, such as linking status, MTU, sending/receiving rate, etc. The trac
data is refreshed every 1 second.