User manual
133ALI-NVR5000P Embedded NVR User Manual
SECTION 8: NETWORK SETTINGS
5. Congure the following Email settings:
— Enable Server Authentication (optional): Check the checkbox to enable the server authentication feature.
— User Name: The user account of sender’s Email for SMTP server authentication.
— Password: The password of sender’s Email for SMTP server authentication.
— SMTP Server: The SMTP Server IP address or host name (e.g., smtp.263xmail.com).
— SMTP Port No.: The SMTP port. The default TCP/IP port used for SMTP is 25.
— Enable SSL (optional): Click the checkbox to enable SSL if required by the SMTP server.
— Sender: The name of sender.
— Sender’s Address: The Email address of sender.
— Select Receivers: Select the receiver. Up to 3 receivers can be congured.
— Receiver: The name of user to be notied.
— Receiver’s Address: The Email address of user to be notied.
— Enable Attached Pictures: Check the Enable Attached Picture box if you want to send email with attached alarm
images. The interval is the time of two adjacent alarm images. You can also set SMTP port and enable SSL here.
— Interval: The interval refers to the time between two actions of sending attached pictures.
— Test: Click this button to send a test message to verify that the SMTP server can be reached.
6. Click Apply to save your settings.
7. Click the Test button to test your Email settings. The corresponding Attention message box will pop up.
8.2.8 Conguring UPnP™
The Universal Plug and Play (UPnP™) feature allows the device to seamlessly discover other network devices and establish
functional network services for data sharing, communications, etc. You can use the UPnP function to enable the fast connection of
the device to the WAN via a router without port mapping.
If you want to enable the UPnP function of the device, you must enable the UPnP function of the router to which your device is
connected. When the network working mode of the device is set as multi-address, the Default Route of the device should be in the
same network segment as that of the LAN IP address of the router.
1. Open the Network Settings menu. Go to Menu | Conguration | Network