User manual
125ALI-NVR5000P Embedded NVR User Manual
SECTION 8: NETWORK SETTINGS
SECTION 8
Network Settings
8.1 Conguring General Settings
Network settings must be properly congured before you connect the NVR to cameras on network, or access it remotely.
1. Open the Network Settings menu. Go to Menu | Conguration | Network
2. Click the General tab.
3. In the General Settings menu, select or enter the following parameters: NIC Type, IPv4 Address, IPv4 Gateway, MTU (valid
range is value range of MTU is 500 ~ 9676) and DNS Server IP addresses. If the DHCP server is available, check the Enable DHCP
box to automatically obtain an IP address and other network settings from the network DNS server.
4. Enter the Internal NIC IPV4 Address, if necessary, to assign IP addresses to the cameras connected to the PoE interfaces.
5. Click Apply to save your settings.