User manual

105ALI-NVR3004P, ALI-NVR3008P Embedded NVR User Manual
8.5 Default
The default option will reset the NVR to its factory settings. Except the network parameters (including IP address, subnet mask,
gateway, MTU, NIC working mode, default route and server port), all other conguration parameters are restored to factory default
settings.
To restore the factory default conguration:
1. Open the Log Information menu. Go to Menu | Maintenance | Default
2. Click OK, then allow the NVR to reboot before continuing.
8.6 Net Detect
8.6.1 CheckingNetworkTrac
You can see real-time information of your NVR network trac, such as linking status, MTU, sending/receiving rate, etc. The trac
data is refreshed every 1 second.
1. Open the Network Trac menu. Go to Menu | Maintenance | Net Detect
SECTION 8: SYSTEM MAINTENANCE