Setup guide

4 www.Observint.com

8. Use the camera record mode Wizard as follows:

a. On the Cameras line at the top of the window, open the drop-down list and select the camera you want to congure for

recording.

b. Click the Start Recording box to check it.

c. Select one of the recording modes: either Normal or Motion Detection mode.

5. In the date and time setup window, click the eld you want to change, then use the drop-down list or setup aid to select the

appropriate values. Click Next to conrm your settings or Cancel to discard them and open the network setup Wizard window.

6. In the Network setup Wizard window, click the eld value you want to change, then use the pop-up aid to enter a new value. By

default, the NVR uses DHCP (Dynamic Host Conguration Processor) to acquire compatible (dynamic, changeable) network settings

from a network DHCP server.

Generally, it is preferable to setup the NVR with a xed network settings, if possible, to assure the NVR has an unchanging IP address

for remote logins. To enable xed network settings, uncheck the Enable DHCP box, then edit the appropriate elds to change the

settings. Consult with your network administrator to determine the best network settings for your NVR. When nished, click Next.

7. Click Next after you congured the network parameters. The HDD management Wizard window will open. If a new NVR is shipped

with a pre-congured HDD, nothing needs to be done in this window. If you installed an HDD or replaced the HDD, select (check the

box for) the HDD, then click Init to setup the disk for the NVR. NOTE: Init will erase all data from the disk. When the initialization is

complete, click Next to continue.