User manual
38
Before you start:
1. Make sure that an HDD is installed. If not, install a HDD and initialize it. Go to Menu | HDD | General.
2. Click Advanced to check the storage mode of the HDD.
a. If the HDD mode is Group, you can select a group of cameras to record to that HDD. See “2.9.4 Conguring HDD Group
mode” on page 39 for more information.
b. If the HDD mode is Partition, you can set the maximum recording capacity for each camera in the DVR:
i. On the Camera line, open the drop-down list and then select the camera you want to set a maximum recording
capacity to.
ii. Click the Max. Record Capacity eld, and then enter the size in GB of the space on the disk you want to allocate to
the camera you selected.
iii. Click apply to save the setting.
iv. Repeat steps 2.b.i through 2.b.iii for each camera in the system.
SECTION 2: INSTALLING THE SYSTEM