User manual

29ALI-HVR3000H Series 960H Hybrid+ DVR User Manual
f. Repeat steps 2.a through 2. e above for a dierent analog camera until the video images of all analog cameras is
congured.
Motion setup
When using motion detection recording, the DVR initially senses for motion everywhere in the video image. You can congure the
DVR to sense for motion in the camera video channel only in specic areas of the video, which is more ecient for the DVR.
The Motion setup menu shows the video image from a camera with a grid covering the area(s) of the video image it is sensing for
motion. When motion is detected in a cell of the grid, that cell is lled. With this feature, you can adjust the sensitivity of the motion
detection parameters to detect (or not detect) motion in the video image.
To adjust the motion detection parameters of a video channel:
1. Open the Camera Motion menu. Go to Main menu | Camera | Motion
2. To change the motion detection settings for a camera:
a. On the Camera line, open the drop down list and select the camera you want to congure.
b. On the Enable Motion Detection line, click the box to check mark it.
c. To change the area of the video image you want to sense for motion, click the Clear button, then drag the mouse across
the area of the video where you want to sense for motion. An example of the result is shown below.
SECTION 2: INSTALLING THE SYSTEM