User manual
7ALI-HVR3000H Series 960H Hybrid+ DVR User Manual
SECTION 1: SYSTEM OVERVIEW
Item Name Function
17 PTZ Control buttons Buttons to adjust the iris, focus and zoom of a PTZ camera.
18 F2 button Cycle through tab pages.
NOTE
Before using the Remote Control, install two AAA batteries.
Remote Control setup
Before using the Remote Control, you must setup the ID number in the Remote Control to match the DVR ID number congured in
the recorder:
1. Start the DVR, and then use the mouse to go to Menu | Settings | General | More Settings. Refer to Chapters 2 thru 6 for
more information.
2. Check and remember DVR ID#. The default ID# is 255. This ID# is valid for all IR remote controls.
3. Press the DEV button on the remote control.
4. Enter the DVR ID# found in step 2.
5. Press the ENTER button on the remote.
If the Status indicator on the front panel turns blue, the remote control is operating properly. If the Status indicator does not turn
blue and there is no eect using the remote control, verify the following:
1. Batteries are installed correctly and the polarities of the batteries are not reversed.
2. Batteries are fresh and not out of charge.
3. IR receiver (on the front panel) is not obstructed.
If the remote still cannot function properly, replace the Remote Control and try again, or contact your vendor provider.
1.1.2 Mousecontrol
A standard 3-button (left/right/scroll-wheel) USB mouse can also be used with this DVR. To use a USB mouse:
1. Plug the USB mouse into the either the front panel or backpanel USB connector of the DVR.